ATI Technologies FireGL? T2-128 Guide de l'utilisateur télécharger pdf (Page 17)

Installing the Hardware and Software 13

Installing the Card

To install your graphics accelerator card, follow these steps:

Switch off your computer and all external options

(monitor, printer, and others). Then disconnect all cables

from the back of your computer. Unplug all power cables

from the electrical source.

Note: If you are disconnecting a peripheral from the

computer or are removing a component from the

system board, wait 10 - 20 seconds after

disconnecting the computer from the electrical outlet

before disconnecting the peripheral or removing the

component to avoid possible damage to the system

board. To verify that all power has been disconnected

from the system, make sure that the standby power

light-emitting diode (LED) on the system board has

gone out.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 60 61

Pas de commentaire

ATI Technologies FireGL? T2-128 Guide de l'utilisateur Page 17